... are delivered from the plant with an average moisture content of 9% for Bl. Storage until processing and the processing itself, should take place in a dry environment. If this precaution is not observed and the boards absorb excessive moisture, it can lead to damage at closed joints and fasteners. Conditions can differ for special applications.

... are recommended with unsanded smooth surfaces for all exterior applications and wall claddings, except where special demands require calibrated surfaces. Panels with calibrated surfaces, where the wood particles are visible at the surface, are generally only used for floors to achieve precise thicknesses as well as for special applications. Should for decorative reasons (e.g. for interior applications) a sanded, colorless laquered exposed surface be required, this must be specified in the order!

In the case of exterior panels where surfaces are subject to direct moisture contact, in conjunction with moisture diffusion conditions at the rear side of panels, DIN 68800-2, Paragraph 6 is to be observed.

... AMROC-PANELS when used exterior such as exposed wall cladding, must be provided with a AMROC color or primed finish to reduce the swelling and shrinkage. It is also possible to apply paint at the building site, however, it will not have the same quality as painting in the factory.

... AMROC-PANELS being monolithic have a very high material structure quality with high screw-holding power and do not delaminate as a result of changes in humidity and temperature. Along with resistance to fungi and termites, this makes AMROC-PANELS the ideal building material in tropical areas.

AMROC-PANELS have been tested according to DIN EN 45.0001. Waste material is classified so as to allow its disposal at above-ground refuse sites.